I have a 3com 4200 and using mrtg/mrts to grather statistics
about the traffic of each port.
The problem is that if i connect from a server from the internet
side (eg. computer at home) everything is workin fine, but when i
try to connect from a server in the same rack (subnet) i get "no response"
from my switch.
I've spend many hours of reading different howto's but i have no clue why
i cannot use snmp on port 1 to 24 on my switch.
The only difference is when i connect from home i'm on port 26, when i
connect from a local server i'm on port 1 for example.
Does anyone has a clue ?
Conrad
about the traffic of each port.
The problem is that if i connect from a server from the internet
side (eg. computer at home) everything is workin fine, but when i
try to connect from a server in the same rack (subnet) i get "no response"
from my switch.
I've spend many hours of reading different howto's but i have no clue why
i cannot use snmp on port 1 to 24 on my switch.
The only difference is when i connect from home i'm on port 26, when i
connect from a local server i'm on port 1 for example.
Does anyone has a clue ?
Conrad