DA times out when trying to access through SSL

[Crusader]

Up to a few hours ago, I was able to connect to DA through dual ports.

One was without SSL (2222) and one with (2223). Nothing changed other than I restarted DA but now whenever I try to connect to DA through port 2223 and the HTTPS protocol, it just times out.

My ssl=0 in my DA config as it was before and ssl_port=2223

Any ideas?

Some logs, my adsl ip has been snipped since it's not really relevant!

009:09:25-13:10:10: Socket write error: fd is connected to a pipe or socket whose reading end is closed. When this happens the writing process will also receive a SIG_PIPE signal. (Thus, the write return value is seen only if the program catches, blocks or ignores this signal.)
2009:09:25-13:10:14: Socket write error: fd is connected to a pipe or socket whose reading end is closed. When this happens the writing process will also receive a SIG_PIPE signal. (Thus, the write return value is seen only if the program catches, blocks or ignores this signal.)
2009:09:25-13:10:43: Socket write error: Unknown error
2009:09:25-13:10:43: Error reading from 66.183.xx.xxx:
2009:09:25-13:10:43: Socket write error: Unknown error
2009:09:25-13:10:43: Error reading from 66.183.xx.xxx:
2009:09:25-15:14:04: Error reading from 66.183.xx.xxx:
2009:09:25-15:23:36: Error reading from 66.183.xx.xxx:
2009:09:25-15:24:18: Error reading from 66.183.xx.xxx:
2009:09:25-15:55:27: Error reading from 66.183.xx.xxx:
2009:09:25-15:55:29: Error reading from 66.183.xx.xxx:
2009:09:25-15:57:04: Error reading from 66.183.xx.xxx:
2009:09:25-15:57:06: Error reading from 66.183.xx.xxx:

I have APF installed but I haven't changed any settings on it either.

Thanks.

 

[Crusader]

Just figured it out, for some reason the process that was running DA through the SSL port stopped responding. It wouldn't even restart when I ran service directadmin restart.

I just kill -9'd the pid.