CustomBuild doesn't show 'Confirm' button

[warg]

Hello,

when a CustomBuild process finished, like updating a software or CustomBuild 2.0 itself, it doesn't offer a confirm button after the 'done' message. Only the cancel button or the cross in top right corner is available. I'm using a prerelease build and latest CustomBuild rev. Someone faces the same issue? I'm running Debian 10. Before some updates, it did work properly.

See screenshot:



Best Regards,

 

[k1l0b1t]

I've never had anything else than a close button. During the process there is a stop button, but that's it.

 

[warg]

You might be right @k1l0b1t. I think the stop/kill button was what I was missing. I just tried it again and now it's visible again but wasn't for the last times, even for longer running updates/processes. I don't know why it was missing but now it's back, even for quite quick processes. Maybe it were some timely coincidences causing this.

 

[k1l0b1t]

Sometimes I have it think the build finished before it finished tho, rarely happens, and is probably when my network connection drops for a few seconds.

 

[warg]

Yea, something like that. It's not a consistent behavior. I just noticed that sometimes it's different than usually.